I just got my 3dc in the mail the other day and started to install. After getting everything routed the way i wanted, I started playing with swapping colors to get use to the way it works. Doing this by hand clicking the switch and running the filament in and out. I noticed that every time I do anything with #3 it moves color #2 in the opposite direction at the same time. I know that isn't right. See attached video. Do I have the 3dc assembled to tightly? after homing it does a little better but after running through 3 or 4 changes it starts having the problem again.
Any ideas?
setup: don't mind the mess as I tore it apart to try and fix the problem. I was originally going to run the Y-pipe directly on the extruder but I'm not sure it will work very well as it weighs more then expect. I was hoping to save time on color swaps with a shorter path. Any ideas on how to do this without having the ptfe tube between the Y-pipe and extruder bend super bad? But this is rather minor problem.
I spent a couple of hours this evening trying to get it to work. I've tried every combination of torque on the screws. Rebuild and cleaned many times. And ran it not attached to the printer. Out of no where it started working correctly. And did this for about 10 minutes of changes. I then power cycle and homed and it was broken again.