Hello
I will be using mk3 from bambu lab P1P
q1 - I bought my mk3 set 2023-05-15 - what firmware version should be already loaded? do i already have mode 3?
q2 - how should I measure the length of the tube - I want to keep the original P1P tube and connect it with the green element to the connector at the back of the housing. Should I count the length from the tip of the hotend head to the entrance of the green mk3 stirrer? Any other way?
q3 - should I program the time interval for the pulses or stay with the one already programmed originally - (I assume it is 0.5s and a multiple)
When was this changed? I have loaded the file into Bambu slicer and the filaments retract too far and load not far enough. It's to the point of frustration. Also my filament run out sensor is being triggered. What gets me is when I manually load the filament with the switch it loads and unloads fine.