I'm trying to figure out how to install the switch on my P1S - the P1P file is supposed to screw into holes on the back, but they are covered by my cable chain. Any suggestions?
I'm working on a new design for it, but for right now, you can use the X1C mount, which is goes over the top of the case and screws into the back using the same two screws.
I had an inspiration on designing the K1 switch mount, which attaches to the motor itself... and I'm working on an update that will also work for the Bambu printers using the same method... that way, all three of their printers use the exact same mounting method.
Bill, you are freaking on it! One of the biggest reasons I bought the 3D Chameleon is because you answered my email personally. I really dig customer service like that!
Looking forward to the new mount - I'll give the X1C mount a shot.
I'm working on a new design for it, but for right now, you can use the X1C mount, which is goes over the top of the case and screws into the back using the same two screws.
I had an inspiration on designing the K1 switch mount, which attaches to the motor itself... and I'm working on an update that will also work for the Bambu printers using the same method... that way, all three of their printers use the exact same mounting method.
Bill