Completely new to 3D Chameleon concept but it seems like it will do what I want..
Before purchasing a 3d Chameleon I had a few questions Ender 5 Plus releated:
Has anyone installed 3D Chameleon on an Ender 5 Plus?
Would you recommend using the Ender 5 Plus stock board or upgrade?
What is the recommended or best firmaware (Marlin/Klipper etc.) for 3D Chamleon?
Any gotchas or upgrades I need to be aware of before dipping my toes into the 3D Chameleon enviroment?
Klipper is (in my opinion) the best firmware for 3D printers. Also, I would recommend saving yourself the pain of getting a 3DChameleon to work. If you look in the support section of this forum, you will see tons of repeated issues with the 3DChameleon with many users.
If you install Klipper, you don't need to purchase a 3DChameleon, and instead build a 3MS. The 3MS is simple and fully open source. I also don't make any money if you build one. It has full documentation, something the 3DChameleon doesn't have, and it is cheap (four colors would cost around $120 in parts).