Hi All
Thinking of getting 3D Chameleon I have Kobra 2 plus thinking of purchasing MK4 / Pro has anyone has any experience installing and get it working good and does the MK 4 set much easier they MK 3 all info would be grateful
Mario
top of page
bottom of page
I'm pretty sure the setup is unchanged (unless you go with some upgrades). Tip shaping is a nightmare, so I would highly recommend the Auto3DClippy. Also, the OLED display is useful to tell what the Chameleon is "thinking". The hardest part (in my experience) is the G-Code, especially the start/end print routines. If you're fine tinkering with G-Code and going through a lot of trial and error, it's not too bad. There's an upcoming filament sensor upgrade, and if you have Klipper, I already made a klipper plugin that utilizes your printer's filament sensor (I'm working on Auto3DClippy support). It's available here if you want to check it out. https://github.com/3DCoded/3dchameleon-klipper