I will get this new CoreXY printer with klipper soon and so i ordered the 3d Chameleon set today. As i understand it will be no problem to set it up with my new printer. I just want to make sure that while i want to print high temperature filaments with it, the system should be somehow moisture proof because these filaments have to be inside closed boxes even while printing. Any thoughts about that ?
top of page
bottom of page
Hey all, here's a beta profile and the printed parts you'll need for the Qidi X Max 3. https://www.printables.com/model/797994-3dchameleon-profile-and-mounts-for-the-qidi-x-max
And here are some pictures of my installation.
Switch mount affixed with two sided foam tape.
Y adapter mount and electronics affixed with two sided foam tape. 3DChameleon mount attached using the two left side metal plate screws. The 3DChameleon just snaps into the mount. Please note: This mount is a remix of willempi25's Flashforge 5M holder for the 3DChameleon, which can be found here: https://www.printables.com/model/756165-3dchameleon-holder I love the idea of this mount... it makes it very easy to service the 3DChameleon if needed.
Bill