Just wondering if you'd consider making the unit 24V capable in future. Make it a bit more streamline for use users that would like to direct connect with via GPIO. have it wired right into our PSU's A buck works fine but since your drivers have 50V caps why not make the board able to take 12-24v?
top of page
To test this feature, visit your live site.
2 Comments
bottom of page
The unit already allows for the use of a 24v power supply, but the GPIO is limited to 5v... as it's a digital pin off the micro controller directly.
Are you asking that the digital pin be 24v capable?
Bill