two days ago I printed the perfect purple cube with the BMG as my extruder,
all I did yesterday was install the 3DC as my extruder,
then with extruder 1 (T0) I printed the purple cube on the right.
with extruder 2 (T1) I printed the golden cube right after which was much better but not perfect (still some weirdness on the top layer)
It's having inconsistent extrusion, especially T0, sometimes it extrudes nicely and then one second later it'll be under extruding. you can see the brim pic where some lines didn't come out at all. This is using the code from your ender 3 v2 test code profile which I had to adapt/rewrite a little bit but the gcode all works.
- also, how do I reverse the feed direction for T2 and T3 in GCode?
Can you confirm that the 3DChameleon is moving off of the active color so that it is not holding the filament. After each color change, it should move to another color that is not being used to allow the BMG to pull the filament through it.
As for reversing it, you need to install our ReverseDrive post processor. Check out our video on the details to install it on our YouTube channel.