Hello,
I have a Creality K1 and have the mk4 set up using the K1 profile off printables, but when I start a print, it travels to the back right corner where I have the button, hits it and just sits on it and makes the mk4 pulse continuously. I tried to copy the info I put in from the code generator but not sure if I did it right or not? I prefer to use Creality Print 6. Does anyone have a gcode that works for this? I have tried everything.
thank you!
I had the same issue. To fix it I had to change the timing of the pulses. Its super important. Check out the printer specific install section theres a few k1 installations.