I have finally installed my MK2+ , purchased July '22, but with the latest firmware.
I'm using Mode 2, and I used the 15 pulse command to set the "Pulse width" to be 2 seconds
I noticed that when the power is removed from the 3D Chameleon, it resets back to the half-second pulse width.
Is this supposed to happen, or is my 3D Chameleon defective?
I was working on adjusting Auto-bed-level G29 command to set the back position, and since i was testing by manually sending gcode, I needed a more time to get to the power plug to unplug unit when the bed hit the switch. I grew fond of the long pulse, but alas, I'll go back to the defaults. Thanks Bill.