Has anyone actually gotten this to work?
I have tried virtually all of the trouble shooting steps (the few there are) and no matter what the filament seems to not be loading far enough to reach to the printers extruder.
I load the filament (t0) in clip it using the clippy change to another filament (t1,t2,t3) so the chameleon backs itself out then when going back to (t0) it does not send enough filament thru to reach the printers extruder..
What am I missing here?
It is in mode 2.
The toolchange gcode is not coming into play as the basic setup is not reaching the stock extruder for the gcode to matter.
I had a rubberband on it and with diagnoses have pulled the unit apart to see exactly what it is doing.
Here is a short video explaining what I am saying.
EDIT:: Video link fixed https://photos.app.goo.gl/xP1te5htkTZdkpom6
Are you sure the 3DClippy is pulling the blade out of the way? It sounds like your path might not be clear. You need to identify where it's getting blocked and see if you can resolve that.
What does it do with the blade removed from the 3DClippy?
Bill