Has anyone created a version of the 3dclippy that will work on the Micro Swiss direct drive extruder?
Also, it would need to work on the left hand side as my CR10-v2 homes on the left and I have my purge wipe/slide/bucket on the right hand side.
top of page
bottom of page
If you are still looking, check this out. I use klipper so setting the servo up wasn't too bad. But I love it.
https://www.printables.com/model/197609-filament-cutter-for-ender-3-microswiss-extruder
I'm not aware of anyone making one yet. The Micro Swiss design, however, has a unique ability for a direct drive.... since there is a large gap between the extruder and the hot end, you can insert the cutter at that point, which is ideal. That way, it'll cut the filament off at the hot end side instead of above the extruder. I have a Micro Swiss Direct Drive setup on order, but I haven't received it yet.
Bill