I printed out the parts for the 3dclippy but I can't see how the blade attaches to the blade holder. There is only a slot that accepts the blade but nothing to keep it in place which allows to just fall out. I suppose I could remix the part and narrow the slot but I'm curious how you keep the blade secured.
top of page
bottom of page
Another question on the 3DClippy -- not until trying to figure it out in detail did I realize that a X homing action will always need to be followed with loading the filament since the filament will be cut. Also, since no tip shaping is required, the gcode generator for MK3 firmware needs to be different. (not only does tip shaping need to be removed, but a home X needs to be included as part of the load process.) Do you have gcode specifically for setups using 3DClippy?
Superglue