This may have been asked and answered before, or perhaps a version of it may have, but my search-fu has failed me.
I have an Ender 3V2 Neo. The PTFE tube goes into the same hole with the wiring for the hot-end and on the left side (facing the printer). I can't figure out which mounting is best to print for the 3dClippy, and how to not squish or cut the wires. Any suggestions?
I have decided to go full MK4Pro, BTW, after much to much time spent tweaking the tip-shaping g-code!
I thought it looked familiar. I've already done that installation. This was an early version of it, but same basic installation.
Bill