I've got a couple of inches of broken filament stuck in one of the tubes. It's down from the extruder, but much closer than it is to the Y. What will be my best approach at removing the filament?
The easiest way is to simply disconnect the PTFE tube and push a piece of filament (long enough to go through the entire system) through the 3DChameleon all the way through to push out the broken piece.
The easiest way is to simply disconnect the PTFE tube and push a piece of filament (long enough to go through the entire system) through the 3DChameleon all the way through to push out the broken piece.
Bill