I have an m5c, wanted to do a trial run, but I can't seem to find a way to bypass the built on runout sensor, M412 s0 command, and no where can I find the settings to bypass it on the AnkerMake m5c not the m5 normal.
Ok, don't trust me on this. You could try to unplug the filament detector from the extruder. I found out where it is from this video: https://www.youtube.com/watch?v=fPtzhuniqI8. Skip to 49 minutes to get to the part with the detector.
Ok, don't trust me on this. You could try to unplug the filament detector from the extruder. I found out where it is from this video: https://www.youtube.com/watch?v=fPtzhuniqI8. Skip to 49 minutes to get to the part with the detector.
You can also remove any runout sensor code (M412) from your Start G-Code in your slicer and add the following command to the begining of the code.
M412 S0; disable filament runout sensorTo bypass it, just stick a piece of filament in it. The Y adapter should feed directly into the extruder.
Bill