I have an Ender 5 pro with a Bondtech DDX direct drive and I have installed the chameleon in the mode 3 configuration with the Y adapter attached to the back of the machine. I have used you MK3 GCode generator, placed the gcode in prusaslicer and when the machine goes to change colors it only moves to the rear and hits the normal endstop and doesnt move to the front where the chameleon endstop is. It only unloads and reloads the same filament. Any ideas?
top of page
bottom of page
In mode 2 can the splitter be placed anywhere or is that only mode 3?
If you are using Mode 3, did you add the commands to move the filament? Mode 2 automatically moves the filament, however, mode 3 needs additional button presses to command it for how far to move it for both loading and unloading.
Search the forum for Mode 3 and check out the P1P Mode 3 video on YouTube to see its operation.
I'm in China and my address to the internet is very restricted so I can post (or even get to) those links right now.
Bill