I've just started using my Ender 3 V2 printer and I've been trying to make figure prints which seem to be challenging due to the need for supports and the scarring that occurs when using the same material for support and desired object. Has anyone had good experience using 3DChameleon to print PVA water soluble supports so that the final product needs less post work? I'm curious if the 3DChameleon is best used for color switches among similar materials or if PLA and PVA can be both loaded easily?
top of page
To test this feature, visit your live site.
Experience using ender 3 v2 with 3DChameleon and PVA supports?
Experience using ender 3 v2 with 3DChameleon and PVA supports?
3 comments
Like
3 Comments
bottom of page
Sure... I have a printer that will use two filaments into each extruder of an IDEX printer. We do offer two color Y adapters as well.