top of page
Filament is not getting into the bottom bowden tube connector in the y adapter. Tried T0,T1,T2, and T3. Hasn't been in extruder yet.
Filament is not getting into the bottom bowden tube connector in the y adapter. Tried T0,T1,T2, and T3. Hasn't been in extruder yet.
2 comments
Like
2 Comments
bottom of page
Is the PTFE tube fully inserted into the pocket above the connector? It needs to fully seated or then filament can catch on the edge. Also, make sure the inside of it is flared to act as a guide or funnel into the tube.
Bill