What is the gcode or mcode for calling the active tool number? I want to cycle the filament at the end of the print to form then end and retract just like it does for the tool change.
I'm on the road right now (at Rapid in Detroit) but I'll post the code I have when I get back Thursday night.
Basically, it'll be the first bit of code that the gcode generator does right up until the "Load Filament" comment in the auto generated gcode... just paste that to the start of your end gcode and you'll be ok.
Perfect. I will cut and paste it. Thanks.
I might add, you don't need to switch to that extruder, as this end gcode will only unload the last used color, which will still be the active one.
I'm on the road right now (at Rapid in Detroit) but I'll post the code I have when I get back Thursday night.
Basically, it'll be the first bit of code that the gcode generator does right up until the "Load Filament" comment in the auto generated gcode... just paste that to the start of your end gcode and you'll be ok.
Bill