Can someone help me out with this gcode.
its unloading for like 10 seconds instead of 5. am i missing something here?
top of page
bottom of page
Can someone help me out with this gcode.
its unloading for like 10 seconds instead of 5. am i missing something here?
yeh its weird that klipper is acting this way. i have it set in mode 3. but i noticed that my machine waits as request
G4 P5000
but then another 5 seconds on G0 E50 F600 and after that it goes to G0 Y-3 to release the button. same for start code.
Can you make sure you are in Mode 3? Mode 2 is a 10 second mode. Press the button for 10 pulses to switch between the modes. It will respond to the current mode.
Bill