So I'm having issues with tube 1 loading and unloading. its not moving it up to the extruder. If i help it when it comes time to unload completely it pulls it around 20mm away from the extruder and then tube 2 hits it and i have to stop everything. If I help it along tube 2 seems to be fine and can unload and load correctly. Is there a torque system going on here that needs adjustment? Also when tube 1 is doing its work i hear a high pitch ringing sort of sound.
top of page
To test this feature, visit your live site.
Edited: Mar 19, 2023
Load unload on 1 isnt working but 2 is.
Load unload on 1 isnt working but 2 is.
8 comments
Like
8 Comments
bottom of page
Hmmm... high pitch ringing is a new one... can you post a video of it? As a side note, can you snap a picture of the top of our electronics... I want to make sure the stepper motor current is correct... it should be slightly rotated to about the 1 o'clock position, instead of straight up and down, and I want to make sure. Bill
does this have anything to do with the the problem you had of the filament in the tube? I see this is an Older post so I didn’t know if this is now resolved or still a challenge? Is this the MK3?
Do you have a short video we can use to troubleshoot this? Bill may have then answer when he is up but I have four of these and have ran into similar issues but usually it was simple