Hi, i red on q&a and saw some posts and videos on chameleon with direct drive, but just to recheck before buying :)
I have Ender 3 pro with microswiss direct drive and like to install 4 color chameleon on it and using Cura.
What are your suggestions/advices for this specific instalation. Can it be done? Do i need to modify code in Cura? i beleive that behinde Y motor bar code are screws for mounting chameleon switch?
Thank you in advanced.
Whole printer current setup:
Direct drive front:
Direct drive side view:
Yep... it'll work just fine on that set up.