Hi, I just finished putting together my new kit. I was trying to get ity loaded and I think it jammed wich made the tube pop out of the motor housing. Is there a good video on taking one of these apart? I saw one where it was being built, but Im worried that I may break something so Id like to see if there is a procedure. What are the fittings called and what size are they, so I can get some replacements? Also is there a cheat sheet with the commands so I can load it without a lot of guesswork and or running to my PC trying to parse out what does what?
Oh, no... we'll send you some new tubes.
Bill
then while testing the other extruders I got another popout. this time I touched nothing.
maybe you got some bad connectors?
I teased it open a little bit and the press fitting fell out. Guess it was just broken.