MK4 and filamentalist rewinder

Hi ,

Just Ordered a MK4 for My Voron Trident 350 (Galileo2 extruder with filametrix cuter). Plan is to Build 4 Filamentalist to rewind the spools , but reading on the filamentalist before ordering the bom and starting to print the parts : I read that filamentalist requires a bit of torque at the filament loading , and i think i remember that the MK4 works based on current draw on stepper (Torque requested): So i get a doubt if the MK4 utilize draw to know when he passes the Y connector or when he reaches the extruder: Will the filamentalist take too much torque from stepper or non consistent torque which could sort off "loose" the MK4 makes him think the filament is in the extruder when he is not yet?

To make a long story short : will MK$ works with filamentalist ? Did anyone tried?

Thanks for feedback and advises

Sebastien

P:S : My apologies for my english : I am french living in Thailand so my english may shock some americans : Forgive the Froggie ...