Will there be a instruction coming up for mode 3 and a video of how mode 3 works in action? Having hard time to work with p1p. I was using one of the config from printables and instead of loading the filament in it was unloading the filament backwards.
top of page
bottom of page
Can we get a reference page under the website instructions that lists all of the pulses, and what they do in each Mode, please, instead of having bits and pieces of information in various forum posts and videos.
ie:
1 pulse in Mode 1 does ...
2 pulses in Mode 1 does ...
...
1 pulse in Mode 2 does ...
...
1 pulse in Mode 3 does ...
Thanks
Paul
Hi bill would love to see your test video soon. great video on installation. althought when i load your profile and run test. its homes the chameleon but then give error that there is no filament in extruder. it didnt even load the filament yet
Not yet. Having some issues on that too . My slicer maybe broke cuz I'm having error loading your config.
Oh, and as for the video, I actually have the P1P right behind me all set up in ready to record the video of it... I will be demoing the entire installation and software setup.
Can you send me a video of what is happening? If it's moving backwards, it sounds like it's either not been homed correctly, or maybe the motors are wired backwards. Also, are you using my profile, or someone elses? My P1P Mode 3 profile is here: https://www.printables.com/model/352274-3dchameleon-mounts-for-the-bambulabs-x1c-and-the-p/files Bill