I just upgraded my board to Chameleon bought last year and also added a display. I wanted to test before installing and I am not getting pulses as when the MK 3 firmware. It displays "Welcome! 3DChameleon MK4 Pro" then goes to "3DChameleon MK4 Pro ready" after about 30 seconds but I do not sense pulses. Does seem to switch randomly T0 and T1 (load and unloads) and also displays "no command" but I do not have a reference to give commands to. Before I try re-flashing the board again, I would like to know if I am missing something.
Note - I did have this installed on my Ender-3 Max Neo but removed after difficulty with keeping the switch in place and aligned, I then removed it and left in box for 6 months. Now I want to install on my Ender-3.
Used this video to flash: https://youtu.be/G7YNcXE9gfU?si=zN3__PAMfLKm6RHb
Thank you,
Gil
Pet portraits offer a wonderful way to pet portraits keep your pet’s memory alive. Each portrait is a unique and beautiful representation of your pet’s spirit and personality.