Finally took the time to sit down and figure out how to get orca working. Ended up having to make a few changes to the generated mk4 gcode but wasn’t difficult. Not sure if it was because of using orca 2.2, my printer, or something with the generator but I’m ready to get it running now on the Flashforge
top of page
bottom of page
My setup was a complete custom setup that I never shared and no longer have the files.
If I remember correctly I used the numbers on the display after manually moving the head to location. I had to make adjustments to the gcode in order for if to work correctly. I had the switch on the y axis. I had to add the x location into the gcode otherwise it wouldn’t work correctly. I think I also had to flip the nozzle and bed heat gcode in startup but that may have been for another reason