Support | 3D Chameleon

To test this feature, visit your live site.

Need help... check out this thread for advice from the experts.

Support

2 3 4 5 6			Recent Activity

Filament shaping tester? EUR USD	4	0	Jun 20

Ad5m Jeffery Strahan	5	0	Jun 20

Not loading filament to extruder First state garage LLC	8	0	Jun 19

Powering 3dChameleon from fan pin on BTT Octopus EUR USD	2	0	Jun 19

Filament wont load to print head First state garage LLC	3	0	Jun 16

Is it possible on Mk4 to actuate servo 90 degrees reversed? topchiyev	4	1	Jun 11

3D Chameleon extruders hot David Blankenship	4	0	Jun 10

Nozzle changer Jack	3	0	Jun 09

MK3S Profile with Filament Sensor Ryan Skinner	7	1	Jun 08

Tuning Guidance Needed Trent B.	6	0	Jun 08

Reverse clippy servo brad miller	8	0	Jun 06

Flyer alie	5	0	Jun 04

Kobra 2 max kev2000	2	0	Jun 03

Servo Horns 3dcoded	27	0	Jun 02

Support for sensor switch for K1MAX faithcts	3	1	Jun 01

Switch wire polarity Evan Carlson	4	0	Jun 01

Anycubic Kobra Max Statten LaPlant	2	0	May 30

Mainboard 3dcoded	2	0	May 30

3DClippy With Ender 3V2 Neo Patrick Wood-Riley	5	0	May 27

Ender 5 S1 Orca slicer klipper g code help Donnie Gates	19	1	May 25

Move exceeds maximum extrusion David Dempsey	3	0	May 25

AutoClippy Tuning las_vegas	10	0	May 24

6th Pulse issue not unloading current Filament Trent B.	2	0	May 22

No Measure setup Bryan James	3	0	May 22

Bypassing Manufactures Extruder ? Larry Fitzgerald	2	0	May 22

3d clippy neptune 4 Nicole Spencer	1	0	May 20

MK4 Pro firmware issue Christopher Saunders #pages	3	0	May 20

SOOO Close on K1 Bryan James	4	0	May 20

Neptune 4 weird stuff Faolon	0	0	May 18

MK4 on K1 filament change acting strange Peter Beery	12	0	May 18

Filament shaping tester?