Can delete if not relevant but I'm curious if anyone has experience with this, can't find anything with the forum search.
I'd like to be able to print model supports in a different extruder/filament(PVA) using prusaslicer, is this possible as far as anyone knows? or is there different software I can use to add decent supports and then print them differently?
thanks.
Actually, it's pretty easy... just go to the Multiple Extruders tab and change the two settings below to the desired extruder.
Now, with that said, it will turn off the purge block... so what I do is add a skirt draft shield that goes all the way up and is several layers thick so the purge can happen inside it instead of the normal purge block.
And the sliced file will look like this with the yellow being the support material:
Bill