Hi, Bill, I'm having an issue with bearing sliding up on selector motor, when it does it, the extrusion doesn't work properly, it can push two filaments at the same time, or do nothing.
I can push the bearing back down, but it goes up again... See pictures attached. Is there a solution to this?
Hi I have the same problem as you. The bearing keep's sliding up.
Ok... two simple fixes are available for that. If you send me an email at bill@3dchameleon.com, I'll send you the stl for that file.
Also, if you push it down, you can add a drop of glue (not super glue, but a rubber style glue) to the top to prevent it from raising up. This is only a temporary solution... printing the part is much better.
Bill