Anyone come up with a good Spool holder for inside an enclosure?
I have a CR10-V2 and no matter how I try to hang all four rolls it creates issues with tension at the Chameleon extruders and back looping when the filament retracts.
top of page
bottom of page
How far back are you retracting the filament? With your Y adapter at the hot end like that, you only need to retract it about 10 inches or so total... just to before the Y adapter. One solution I found is to make sure the inputs to the 3D Chameleon have a guide... that way it forces the filament through the guide first... for example... add a length of PTFE tube before the 3D Chameleon... once it retracts, that tube will weigh it down some and cause it to drop instead of try to be rewound.