Whenever I give commands to the setup, the motor will load and then unload. When holding for the 5th pulse, it will home and then unload. Video will be added as a reply.
Well... the video didn't come through... but did you by chance take it apart and put the tubes on the other side? If so, the fix is easy... at the extruder motor's connector, simply swap the 1st wire with the 3rd wire (from either end.) You can use a fine blade to lift up the locking tab on the connector and carefully pull out the wire. Do that with both wires, then reinsert them in the other wire's place.So, if the order was "Green/Red/Blue/Black" you can swap it to either "Blue/Red/Green/Black" or to "Green/Black/Blue/Red". Both of those changes will reverse the direction of the motor.
Pictures of how it currently is setup. I haven't changed the wires....yet.
I did take it apart. But the wire swap will be super easy. Ty
Well... the video didn't come through... but did you by chance take it apart and put the tubes on the other side? If so, the fix is easy... at the extruder motor's connector, simply swap the 1st wire with the 3rd wire (from either end.) You can use a fine blade to lift up the locking tab on the connector and carefully pull out the wire. Do that with both wires, then reinsert them in the other wire's place. So, if the order was "Green/Red/Blue/Black" you can swap it to either "Blue/Red/Green/Black" or to "Green/Black/Blue/Red". Both of those changes will reverse the direction of the motor.
Bill