I was having some challenging times with filament passing through the original adapter, so I designed my own adapter with little to no filament friction! I’m very happy with the outcome and can’t wait to start printing. I disabled the wipe tower and have attached a brush at the end of the x axis so I can wipe the nozzle after it purges the next color off the build plate.
https://share.icloud.com/photos/0ffarCOLvS4uhmYhCQs54TZxA
I've found that loosening the screw on the Y adapter by just a smidgen helps take some of the pressure off, let the filament flow better. If that helps any. Either way I'm excited to see your take, got a printables or thingiverse link? The icloud link is dead
hey guys, are you using the Kobra Max as well? if so, where did you mount your sensor? I've tried the front, side and back, and then figured out (I think, but haven't tried it yet) that I can't measure from the home position. did y'all have this issue?
would love to see a pic, or STL of what you built. The iCloud link isn't working.
very interested in this, any plans to share the files? I have issues with my T2 getting stuck in the y splitter causing failures.
I have the Kobra Max as well, and was thinking about getting the Chameleon so I don't have to mess around with manually pausing or adding in the pauses in Cura.
Have you had any issues with Cura if you use Cura?
What is the print quality like? I'd reckon it should be the same, but thought I would ask.
I wasn't able to see the pictures, and I haven't seen any new posts from you, so I figure either things went good for you, or they went horribly wrong lol
Interesting! I had similar problems with sticking in the Y but the 3DClippy solved that for me. I’m interested in your purge bucket setup can you share info on that?
I can't design but I was scouring the web looking for something I liked better than the current Y. I will give yours a shot. Good job.
https://share.icloud.com/photos/0ffarCOLvS4uhmYhCQs54TZxA