top of page
Forum Posts
mustangwagz
Mar 16, 2023
In Your 3D Chameleon Creations
Did a samsqantch (Sasquatch) diarama with the chameleon as a test to check my functions and make sure all was good.
need to come up with a way of keeping the idle filaments separate when they’re not in use.. might have to do reverse Bowden outta the chameleon into a Tupperware container..
0
1
338
mustangwagz
Mar 16, 2023
In Support
https://www.printables.com/model/424814-p1p-mount-and-gcodes-for-3d-chameleon above is the link for all brackets and coding im using currently to successfully operate my chameleon on my P1P! and its killing it!! haha. Good job bill. thanks again for the help!
2
0
53
mustangwagz
Mar 14, 2023
In Your 3D Chameleon Creations
Ole girl is doing good. Now that I’ve perfected the coding, I’ll be passing it off to bill so he can distribute as wanted.
0
0
440
mustangwagz
Mar 08, 2023
In Your 3D Chameleon Creations
welll here it is. First print off my p1p. I have a few things to adjust and discuss with bill, however it went pretty decent. Once I get the bugs ironed out, it oughta be a solid setup!
1
0
367
mustangwagz
Mar 07, 2023
In Support
Currently working with bill to get my p1p setup to be able to load via the OEM tube through the rear. To do this, you have to enable mode 3. (which ive done). Has anyone else made their bambu use the chameleon using the same method yet?
0
2
135
mustangwagz
More actions
bottom of page