top of page
Forum Posts
rorionstar
Aug 27, 2022
In Getting Started
ok so i think i will have to change the firmware with my vyper because i dont see nothing in cura for a tool change gcode in my settings, Also the bracket for the tube i dont have that same setup for my vyper,
0
6
145
rorionstar
Aug 06, 2022
In Getting Started
I am thinking about getting chamaleon but i have a vyper so i want to make sure the unit would work and see if there are any modfications outside of taking off the end of filament sensor?
0
1
56
rorionstar
More actions
bottom of page